Passive optical distribution
Match splitter or WDM architecture to wavelength plan, ratio, package and insertion-loss targets.
A compact multi-fiber MT contact for dense ribbon-fiber interfaces where alignment, vibration resistance and an approved mating design are required.
The MT-Type Fiber Optic Connector is a multi-fiber contact intended for dense optical interfaces such as GDJ8, LRM and VPX-style connector systems, or for connection to an optical module through an MT clip. A ribbon-fiber contact places several optical paths in one compact ferrule and uses elastic contact in the mating system.
This is not a universal field connector. Ferrule geometry, fiber count, alignment hardware, clip arrangement and the surrounding connector must be reviewed as one interface, particularly where vibration and impact performance matter.
Provide the mating connector or module, MT ferrule drawing, fiber count, ribbon sequence, guide-pin arrangement and available strain relief. The current data also lists sinusoidal and random vibration plus impact conditions, but acceptance levels must be tied to the complete assembled connector and approved test plan.
Huijue Group can review sample-based or drawing-based MT assemblies, including ribbon preparation and private-label packaging. Feasibility depends on ferrule tooling, dimensional tolerances, alignment method, qualification tests and order quantity; no sample should be copied into production without an approved specification.
Operating Temperature: -40℃~+80℃
Vibration: Sinusoidal Vibration: Frequency: 10~2000Hz, Acceleration: 196m/s²; Random Vibration: Frequency: 10~2000Hz, Power Spectral Density: 0.2g²/Hz
Shock: Acceleration 490m/s²
Mechanical Life: 500 Cycles
Insertion Loss of Optical Contacts: Single-Mode: ≤0.8dB, Multi-Mode: ≤0.7dB
Bit Error Rate (BER): Not Exceeding 10⁻¹²
Control end-face cleanliness, guide-pin condition, ribbon strain relief and mating force. Vibration or impact suitability must be verified on the finished connector system, not inferred from the MT contact alone.
Buyer Questions
Answers specific to MT-Type Fiber Optic Connector selection, configuration and purchasing.
No. MT describes the multi-fiber ferrule/contact; the complete connector adds a housing, alignment and latching arrangement.
A sample can support engineering evaluation, but production requires an approved drawing, materials, tolerances and qualification plan.
It is the current listed mechanical-life value. A custom complete assembly must be validated against its own approved test conditions.
Use the deployment context to narrow the configuration before comparing dimensions, capacities and options.
Match splitter or WDM architecture to wavelength plan, ratio, package and insertion-loss targets.
Coordinate connector, polish, fiber grade, polarity and cable length across patching points.
Plan MPO/MTP trunks and harnesses around port mapping, breakout format and rack density.
Select splicing, cleaning and test tools for the connector types and measurements used on site.
Before quotation: confirm capacity, interfaces, installation environment, power conditions, quantity and required options.